Magellan MG5000 Manuel d'installation télécharger pdf (Page 15)

MG5000 11

Figure 8: Paradox Memory Key

Part 4: Access Codes

The Magellan MG5000 control panel supports the following access codes:

4.1 Access Code Length

Section [701]: System Options

Option [1] OFF = 6-Digit Access Codes

Option [1] ON = 4-Digit Access Codes (default)

All access codes can be set to lengths of either 4- or 6-digits. When the 4-digit option is selected, entering a 4-digit code will allow

access. Using the 6-digit option, entering 6 digits is required to allow access.

If the access code length is changed from four digits to six digits when access codes have already been

programmed, the control panel will automatically add the last 2 digits by using the first 2 digits. For example, if

the access code is 1234 and you switch to 6 digits, the code will become 123412. Be sure to verify the access

codes after switching from 4-digit access codes to 6-digit codes. When switching from six digits to four digits, the

control panel will simply remove the final two digits of the access code. For example, 123456 will become 1234.

4.2 Installer Code (Default: 0000 / 000000)

The Installer Code is used to enter the MG5000‘s programming mode, which allows you to program all the features, options and

commands of the control panel. The Installer Code can be 4- or 6-digits in length (see Access Code Length on page 11) where

each digit can be any value from 0 to 9. The Installer Code cannot be used to program Master Code 1, Master Code 2 or user

access codes. To program the Installer Code press:

[

ENTER]+ [CURRENT INSTALLER CODE] + [397] + new 4- or 6-digit Installer Code

Installer Code [397]: Used to program all control panel settings except user access codes.

Maintenance Code [398]: The Maintenance code is similar to the Installer code. It can be used to enter programming

mode, which allows you to program all the features, options and commands except for the

MG5000’s communication settings.

System Master Code [399]: Provides full access. Arm and disarm using any method described in the User Code Options

below as well as program the user access codes.

Master Code 1: Permanently assigned to partition 1. Same as a regular user code except it can also program

access codes for user codes assigned to partition 1.

Master Code 2: Permanently assigned to partition 2. Same as a regular user code except it can program

access codes for user codes assigned to partition 2. If the system is not partitioned Master

Code 2 will be assigned to partition 1.

29 User Codes: Can arm and disarm as per User Code Options on page 12.

Jumper ON =

Read from and/or write to

memory key.

Paradox

Memory Key

PMC-3/

PMC-4

Jumper OFF =

Write protected (read from

memory key only)

Insert Paradox Memory Key

onto the ‘MEMORY KEY’

connector.

Partial view of Magellan

MG5000 control panel

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Magellan MG5000 Manuel d'installation Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Magellan MG5000