Magellan MobileMapper - GPS Software Spécifications télécharger pdf (Page 13)

English

Setting the Mini-USB Port (I/O Module)

The mini-USB port located on the I/O module can be set to op-

erate in one of the following two configurations:

- USB port emulating a conventional serial port. When set

in this configuration, the USB port is made available as

“COM6” in the GPS Port Configurations utility.

- USB port especially intended for use in conjunction with

Microsoft ActiveSync.

To change the USB port settings, do the following:

- Tap on , then Settings>Control Panel.

- Browse the items listed in the control panel to find the

USB device switcher icon.

- Double-tap this icon. This opens a new dialog showing the

possible two settings:

• USB serial: Tap this button to set the USB port as a

serial port.

• USB serial for ActiveSync: Tap this button to set the USB

port for use with Microsft ActiveSync.

Warning! The change will be effective only after you have

re-booted the unit. A message at the bottom of the dialog

indicates the future status of the USB port, once the unit

has been re-booted. If you keep the USB port setting

unchanged, then the message indicates the current set

ting of the USB port.

- Tap OK to close the dialog.

Resetting MobileMapper CX

To reset MobileMapper CX, hold down the ESC, Enter and Pow-

er keys simultaneously until the screen goes blank. The Mo-

bileMapper CX switches off. You can then power on the device

by pressing the power button.

Note that using this key combination does not reset the GPS

receiver. To reset only the GPS receiver, see GPS Reset on

page 46.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 85 86

Pas de commentaire

Magellan MobileMapper - GPS Software Spécifications Page 13