Magellan MSS Manuel d'installation télécharger pdf (Page 20)

MAKING COAX CABLES

STEP 1 – Cut the Coax cable to length. Make sure the cut is clean

STEP 2 – Place the Coax Use the Coax Stripper

Tool

Note where the red arrow shows the coax end is

flush with the V notch of the coax stripper.

STEP 3 – Place a finger in the hole of the coax

stripper and twirl the stripper around the cable 4

or 5 times...making complete circles.

STEP 4 – Pull the stripper away from the cable

(without opening the stripper) so that you remove

a segment of coax shielding. In fact, you have

made 2 cuts at the same time.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

Magellan MSS Manuel d'installation Page 20